Power to Enforce.
Stalker DUAL SL Quick Guide
Display
PWR
Turns unit
ON / OFF
Remote Control
FASTER
Selects FASTER mode in opposite
direction and stationary modes
800-STALKER
855 East Collins Boulevard n Richardson, Texas 75081
972.398.3780 n Fax 972.398.3781
applied concepts, inc.
Copyright © 2018 Applied Concepts, Inc. All Rights Reserved. Specications are subject to change.
Power to Enforce.
Stalker DUAL SL Quick Guide
011-0265-00 Rev A
ANT
Switches between front
and rear antennas
SAME/OPP
Alternates between Same- and
Opposite-Direction Modes
MOV STA
Toggles between Moving and
Stationary Modes
XMIT/HLD S/S
Toggles between transmit and hold
(standby)
LOCK / REL
Alternates between target lock
and release functions
LIGHT
Activates remote control backlight
and cycles display brightness
PS 5/20 1
Selects one of three low end
patrol speed tracking thresholds
PS BLANK
Adjusts Doppler volume and
beep tone volume
SPEAKER ICON
Adjusts Doppler and beep
volume levals
SEN 100
Adjusts radar range up or down.
SQL10
Toggles squelch override
on and o.
SELF TEST
Initiates diagnostic check of
display and antenna
For a more detailed explanation of the Dual’s operation,
download the operator manual, part # 011-0100-00,
at www.stalkerradar.com/law_dual.php.
(Under DOWNLOADS/VIDEO tab.)
011-0276-00 Rev A
DISPLAY ICONS
Indicate status of
various radar functions
To return to normal radar mode,
press the XMIT/HLD button.
Tuning Fork Testing
To perform a tuning fork test: turn the unit on by
pressing the PWR button (if necessary). Press
the ANT key to select the front antenna. Press the
SELF TEST key and wait for the FORK icon to
illuminate following the internal test sequence.
Stationary
Using the MOV/STA remote button, set for
Stationary Mode. Strike lowest speed tuning fork
and place in front of active antenna.
Target reading should match speed on fork ± 1
mph.
Moving Opposite
Using the MOV/STA remote button, set for
Moving Opposite-Direction Mode.
Strike the lowest speed tuning fork and place in
front of active antenna. Patrol Window will show
speed stamped on the fork.
Strike the highest speed tuning fork and hold in
front of the antenna along with the lowest speed
fork.
Target Window will show the dierence in speed,
typically, 25 Patrol, 15 Target.
Moving Same
Using the SAME/OPP remote button, set for
Moving Same-Direction Mode.
Strike the highest speed tuning fork and place in
front of active antenna. Patrol Window will show
speed stamped on fork.
Strike the lowest speed fork and hold in front of
the active antenna along with the highest speed
fork.
Target Window will show the combined speed,
typically, 40 Patrol, 65 Target.
To Next Page
Need help?
General