Need help?Do you have a question about the STAMOS soldering S-LS-15 Basic and is the answer not in the manual?
General| Input Voltage | 230 V |
|---|---|
| Power | 15 W |
| Temperature Range | 200 - 450 °C |
| Cable length | 1.5 m |
| Heating time | 3-5 minutes |
Safety instructions for electrical devices, reading manual, grounding, power cables, damp environments, solar radiation, cooling, cleaning.
Manual accessibility, employee instruction, airflow, combustible materials, initial smoke, hot parts, regular cleaning.
Technical specifications for the infrared lamp: voltage, power, area, temperature range.
Technical specifications for the soldering iron: temperature range, output power, stability, tip resistance/voltage.
Use for soldering/de-soldering electronic components (SOIC, CHIP, QFP, PLCC, SMD, BGA) and shrinking, paint drying, etc.
Identification of front panel controls and displays (switches, displays, buttons, knob).
Identification of back panel connections and controls (main switch, sockets, unit switch, light switch).
Checking packaging integrity upon receipt, contacting transport company for damages, keeping packaging materials.
Requirements for the work surface: suitable size, levelled, dry, heat-resistant, proper height, grounded power cord.
Setup, power connection, turning on, temperature setting, display readings, shutdown.
Setup, nozzle connection, power, turning on, temperature setting, airflow adjustment, shutdown.
Setup, tip connection, power, turning on, temperature setting, shutdown.
Setup, connection, turning on, temperature setting, shutdown.
Using switch (6) to change temperature units between Celsius (°C) and Fahrenheit (°F).
Procedure for setting temperature compensation for soldering iron, SMD rework, preheater, and infrared lamp.
Meaning of display indicators like "---" (stand-by) and "S-E" (disconnected/sensor issue).
Requirement to place soldering iron and HOT AIR gun in their holders when turning on the device.
Keeping the SMD rework gun outlet clean and free from obstacles for proper airflow.
Adjusting airflow for small nozzles, avoiding high airflow/temperature for long periods to prevent damage.
Importance of good room ventilation and device placement for heat dissipation.
Safe installation of nozzles, not overtightening screws, changing parts when cold.
Avoiding flammable materials, not touching hot parts, not directing hot air at body.
Cleaning SMD rework gun outlet for airflow, preventing tip oxidation with sponge/tin.
List of parts for the hot air rework heating element replacement (covers, element, heater, etc.).
Step-by-step guide for replacing the heating element, including disassembly and reassembly.
List of parts for soldering iron tip and heating core replacement (nut, tip, housing, heater, etc.).
Step-by-step guide for replacing the soldering iron tip and heating element.
Ensure the soldering iron is completely cold before attempting replacement.
Procedure for replacing the soldering iron tip, including housing and nut.
Procedure for replacing the heater element, including housing, board, and wires.
List of parts for infrared lamp and cover replacement (cover, ring, quartz plate, lamp, components).
Step-by-step guide for replacing the infrared lamp and its cover.
Instructions on how to clean the device, avoiding specific cleaning agents and ensuring disconnection.
Regularly check for any device damage and stop use if found, contacting customer service.
Information needed for customer service (invoice, serial number, part description) and caution against opening the device.
To Next Page
