Stanley AC6511 - Using the Air Compressor; Initial Operation and Tank Fill; Tool Connection and Pressure Control

13
USING THE AIR COMPRESSOR
Before starting run through this simple list:
1. Drain tap – open and drain tank
2. Drain tap – close fully
 #HECKPOWERLEADFORANYDAMAGE)FDAMAGEDHAVEREPLACEDBY
an authorised service centre.
 0LUGAIRCOMPRESSORINTOASTANDARD6!MP!#POWERPOINT
ANDTURN/.
 0USHTHESWITCHTOTOTURN/.SEEPAGE0IC
 !LLOWTHEAIRCOMPRESSORTOlLLTHEAIRTANK
 4URNTHEAIRCOMPRESSOR/&&
 4URNTHEPOWERPOINT/&&ANDDISCONNECTTHEPOWERLEADFROMTHE
power point.
9. Connect your air hose and air tools.
 2ECONNECTTOTHEPOWERLEADTOTHEPOWERPOINTANDTURN/.
 4URNYOURAIRCOMPRESSOR/.
 .OTE$EPENDINGONTHELENGTHOFAIRHOSEUSEDTHEAIR
COMPRESSORMAYSTARTIMMEDIATELYITISTURNEDONDUETOTHESIZE
of the tank.
 9OUCANBEGINUSINGTHECONNECTEDAIRTOOLSANDTHEAIR
COMPRESSORWILLSTARTANDSTOPWITHOUTWARNING4HISIS
CONTROLLEDBYTHEPRESSURESWITCH4HESEPRESSURESETTINGSARE
FACTORYSETANDSHOULDNOTBECHANGED
0UMPINGSTARTSATMINIMUM03)ANDSTOPSATMAXIMUM
03)/NCETHEINITIALPUMPUPSTAGEHASlNISHEDYOUCAN
ADJUSTTHEOUTLETAIRPRESSURETOTHETOOLSRECOMMENDEDWORKING
pressure and open the air tap fully.
RUNNING IN YOUR NEW AIR COMPRESSOR
Your new air compressor does not require running in:
4HISCOMPRESSORISREADYTOUSEIMMEDIATELYASAPORTABLECOMPRESSOR
)FUSINGASAWALLMOUNTEDCOMPRESSORENSURETHECOMPRESSORISFULLY
ASSEMBLED