Stanley AC6511 - Maintenance and Troubleshooting; Common Compressor Problems

17
If your compressor does not start
s#HECKTHATYOUHAVEPLUGGEDTHEPOWERLEADINTOASTANDARD
6!MPPOWERPOINTANDTURNEDTHESWITCH/.
s#HECKTHATYOUHAVETURNEDTHEAIRCOMPRESSOR/./&&SWITCH
/.
s4HEAIRTANKMAYBEFULL5SEYOURAIRTOOLANDTHEAIR
COMPRESSORSHOULDSTARTWHENTHEPRESSUREDECREASESTO03)
If your compressor does not build up pressure
s #HECKTHATTHETANKDRAINTAPISSEALED
s #HECKTHATTHEAIRlTTINGISNOTLEAKING)FLEAKINGREPLACE
If your compressor smells like burnt oil
s 5SINGBEYONDTHEDUTYCYCLEALLOWTOCOOLFORMINUTES
BEFOREREUSINGTHISAIRCOMPRESSOR
Call SMG for your closest centre,
Aust. 1300 660 457 N.Z. 0800 474 876.
MAINTENANCE
Daily: Before Use
1. Seal the tank drain tap, see page 16, Pic. 11 & 12.
2. Check safety valve operation, see page 15, Pic. 9.
After Use
1. Open the tank drain tap, see page 16, Pic. 11 & 12.
 7IPEDOWNTHEAIRCOMPRESSOR
3. Store safely and securely.
TROUBLE SHOOTING