Need help?Do you have a question about the Stanley BC15 and is the answer not in the manual?
General| Brand | Stanley |
|---|---|
| Model | BC15 |
| Category | Battery Charger |
| Language | English |
Specifies the charger's purpose: charging 12V lead-acid batteries for indoor, household use.
General precautions for using the battery charger safely and appropriately.
Guidance on storing the appliance properly after use.
Instructions for checking the appliance for damage and repair procedures.
Warnings and advice regarding the safe use of the power cord.
Ensures power supply matches rating plate and addresses cord damage hazards.
Precautions for charging specific battery types and cord replacement.
Safety precautions when working with batteries and handling battery fluid.
Instructions for handling contact with liquid crystal from the display.
Advice on personal protective equipment and avoiding hazards with batteries.
The liquid crystal display screen on the charger.
Button for checking the vehicle's alternator function.
Button to check the battery's current voltage status.
Button to activate the engine start timer function.
Button to initiate the battery charging process.
Button to start the battery reconditioning cycle.
The red clamp for connecting to the positive battery terminal.
The plug for connecting the charger to the AC power outlet.
The black clamp for connecting to the negative battery terminal.
Ensure charging only 12V lead-acid batteries and confirm voltage.
Warnings about explosive gases, ignition sources, and proper placement.
Describes connecting to battery while in circuit or disconnected.
Hazards of incorrect connection, short circuits, and battery/charger placement.
How to identify positive and negative battery posts by diameter.
Steps for connecting red clamp to positive and black clamp to negative posts.
Connecting the AC plug to the mains socket after clamp connections.
Order of operations for safely disconnecting the charger from the battery.
Hazards of incorrect connection, short circuits, and battery/charger placement.
How to identify positive and negative battery posts by diameter.
Steps for connecting red clamp to positive and black clamp to negative posts.
Connecting the AC plug to the mains socket after clamp connections.
Order of operations for safely disconnecting the charger from the battery.
Step-by-step guide to charging a battery, including LCD indicators and warnings.
Procedure to test the vehicle's alternator output under no-load and load conditions.
How to check battery voltage before, during, and after charging.
Procedure to use electrical pulses to restore battery performance.
Function to assist with starting a vehicle engine by managing charge cycles.
Common issues and checks when the charger is not charging the battery.
Guidelines for storing the unit in a clean, dry, cool place.
To Next Page
