To Next PageTo Next PageWhat to do if Stanley Gate Opener door moves slowly and shows code 33, 34, or 36?
If your Stanley Gate Opener door moves slowly over several cycles and displays status code 33, 34, or 36, try resetting the power. If the code doesn't clear after resetting the power, call Tech Support.
Why does my Stanley Gate Opener show status code F2-F3?
If your Stanley Gate Opener displays status code F2-F3, it indicates a monitored beam failure. To resolve this, verify the wiring and ensure that the 'holding beam type' (index 20) is set appropriately, either to 'Monitored Beam' or 'Non-Monitored Beam'.
What to do if Stanley Gate Opener displays status code E4?
If your Stanley Gate Opener displays status code E4, verify the sensor wiring and safety logic setting.
What to do if Stanley Gate Opener hits the open stop?
To resolve the issue of your Stanley Gate Opener door hitting the open stop or full open bumper, increase the Open Check Length (Index 3).
General| Application | Commercial |
|---|---|
| Motor Type | DC Motor |
| Maximum Gate Weight | 5200 lbs |
| Maximum Gate Length | 40 ft (Single Slide), 80 ft (Bi-Parting) |
| Opening Speed | Adjustable, up to 36 in/sec (914 mm/sec) |
| Closing Speed | Adjustable, up to 36 in/sec (914 mm/sec) |
| Safety Features | Obstacle detection |
Manual provides instructions for iQ Controller and automatic slide door systems.
States that ANSI/BHMA and UL requirements must be met before operation.
Covers new door installations where the iQ is factory-installed and wired.
Details requirements for the power source, including voltage, frequency, and circuit rating.
Provides steps for de-energizing and connecting incoming power wiring to the control box.
Details tuning the iQ controller using its built-in pushbutton switches.
Guides on making final adjustments to the door system after initial setup.
Addresses entrapment protection criteria, including forces, speeds, and door weights.
Provides common symptoms and their corresponding remedies for iQ Controller issues.
