To Next PageTo Next PageWhat to do if Stanley Gate Opener door moves slowly and shows code 33, 34, or 36?
If your Stanley Gate Opener door moves slowly over several cycles and displays status code 33, 34, or 36, try resetting the power. If the code doesn't clear after resetting the power, call Tech Support.
Why does my Stanley Gate Opener show status code F2-F3?
If your Stanley Gate Opener displays status code F2-F3, it indicates a monitored beam failure. To resolve this, verify the wiring and ensure that the 'holding beam type' (index 20) is set appropriately, either to 'Monitored Beam' or 'Non-Monitored Beam'.
What to do if Stanley Gate Opener displays status code E4?
If your Stanley Gate Opener displays status code E4, verify the sensor wiring and safety logic setting.
What to do if Stanley Gate Opener hits the open stop?
To resolve the issue of your Stanley Gate Opener door hitting the open stop or full open bumper, increase the Open Check Length (Index 3).
General| Operating Voltage | 24 VDC |
|---|---|
| Power Input | 120V AC |
| Operating Speed | Adjustable, typically 12-18 inches per second |
| Compliance | UL 325 |
| Motor Type | DC motor |
| Opening Speed | Adjustable, typically 12-18 inches per second |
| Closing Speed | Adjustable, typically 12-18 inches per second |
| Power Supply | 120V AC, 60Hz |
| Safety Features | Obstruction detection |
Manual covers installation, wiring, and tune-in for iQ Controller and specific door systems.
Details requirements for power source, circuit rating, and avoiding interference.
Step-by-step guide for tuning the iQ Controller via pushbuttons.
Outlines critical aspects for compliance with ANSI/BHMA A156.10.
Specifies criteria for UL 325 entrapment protection, including forces and speeds.
Requirements for Low Energy doors per ANSI/BHMA and IBC-2018.
Provides specific adjustments for common door performance issues.
