Need help?Do you have a question about the Stanley FATMAX FMC710 and is the answer not in the manual?
General| Voltage | 20V |
|---|---|
| Battery Type | Li-ion |
| Weight | 3.5 lbs |
| Power Source | Battery |
| Chuck Size | 1/2 inch |
| Chuck Type | Keyless |
| Number of Clutch Settings | 24 |
| Display | No |
| Battery | Included |
| Type | Cordless Drill |
Read all safety warnings and instructions. Failure to follow may result in electric shock, fire, or serious injury.
Keep work area clean and well lit. Cluttered or dark areas invite accidents.
Power tool plugs must match the outlet. Never modify the plug. Unmodified plugs reduce risk of electric shock.
Stay alert, watch what you are doing and use common sense. Do not use while tired or under the influence of drugs or alcohol.
Do not force the power tool. Use the correct tool for application. The correct tool does the job better and safer.
Do not use the power tool if the switch does not turn it on and off. Any tool not controlled by the switch is dangerous.
Hold tool by insulated surfaces if accessory contacts hidden wiring. Secure workpiece with clamps, not hand.
Contact with or inhalation of dusts from sanding may endanger health. Wear dust mask, remove dust thoroughly.
Battery safety: do not open, expose to water, store above 40°C. Charger safety: do not charge damaged batteries or non-rechargeable ones.
Disconnect tool before fitting. Squeeze lever, slide accessory, ensure engagement, release lever. Scrapers/blades can mount at an angle.
Charge before first use or when power is low. Battery may warm. Charge between 10°C-40°C. Indicator blinks when charging.
To Next Page