PB2 • 3
FEATURES
1. On/Off Switch
The ON/OFF switch turns the power on and off.
2. Battery Compartment– Low Battery Indicator
The laser will blink on and off 8 times between 8 second intervals when
there is approximately 2 hours of battery life remaining. Average life of the 3
“AA” batteries is +/- 15 hours of intermittent use. It is always a good idea to
put extra batteries in the carrying case.
3. Tripod Mount– 1/4-in x 20
Easily mounts to 1/4-in x 20 thread tripod for versatility.
4. Magnetic Fastening
Designed with magnets for attachment to steel objects, such as studs. This
allows for a secure hold while taking measurements.
5. Two (2) Self-Leveling Laser Diodes– ±5º
A warning to let you know that the unit is out of level beyond its 5º self-level-
ing capability. If the lasers start blinking quickly, just move laser to a more
level position.
CALIBRATION
This unit is factory calibrated and should never need calibration. But if it
needs to be calibrated, it must be done by a factory authorized service
center.
To Next Page
Loading...
Need help?
General
