Stanley Fatmax SXPW2823K - Page 10

10- ENG
7
Release Air
from System
Release all
air from pump and
high pressure hose by
depressing trigger until a
steady stream of water is
present. Approximately
30seconds.
8
Verify the
Engine Switch
is turned to the
ON Position
9
Move the
Choke to the
CHOKE
Position
10
Pull the Recoil
Starter Grip
Pull the
recoil starter grip to
start theengine.
11
Move the
Choke to the
RUN Position
Gradually move the
Choke to the RUN Position
after enginestarts.
DANGER: This Guide is not a substitute for reading the operator's manual. User must
read and understand operator's manual before using thisproduct.