To Next PageTo Next Page
Need help?Do you have a question about the Stanley SXPW2823 and is the answer not in the manual?
General| Maximum Pressure | 2800 PSI |
|---|---|
| Flow Rate | 2.3 GPM |
| Engine Type | Gasoline |
| Power Source | Gasoline |
| Hose Length | 25 feet |
| Nozzles Included | 5 |
Definitions of DANGER, WARNING, CAUTION, NOTICE symbols used in the manual.
Dangers of CO from engine exhaust and safe operation locations.
Risks of injection injury and chemical hazards from product/exhaust.
Discusses risks from fuel, heat, and environment, with prevention methods.
Dangers of exhaust fumes and cleaning fluids; safety measures.
Hazards of high-pressure spray and leaks; safety precautions.
Dangers from high-velocity spray and projectiles; safety measures.
Covers safe operation, starting, handling, and environmental factors.
Precautions for moving and storing the pressure washer.
Warnings and prevention for electrical hazards.
Advice on using chemicals safely.
Dangers of over-inflating tires and spray on tires.
Warning about hot engine parts and avoiding burns.
Guidance on avoiding injury when lifting the unit.
Steps to install the wheels on the pressure washer.
Attaching handle, adding oil, and gasoline.
Attaching garden hose, pressure hose, and wand.
Attaching wand and quick-connect nozzles.
Ensuring water supply is fully open.
Purging air from the pump and hose.
Positioning switch and choke for starting.
Pulling the recoil starter grip.
Identification of key parts like pump, engine, hose, gun.
Unpacking and attaching the handle assembly.
Attaching wheels and storing nozzles.
Connecting the spray wand and high pressure hose.
Definitions of PSI, GPM, CU, Bypass Mode.
Thermal relief valve, detergent system, water supply.
Methods to adjust pressure, like changing distance.
Selecting nozzles and adjusting the regulator for pressure.
Step-by-step instructions for safely changing nozzles.
Connecting hose to pump and placing in solution.
Fitting the black nozzle for chemical application.
Flushing the chemical system with clean water.
Critical warnings for fueling and hose protection.
Steps for fueling, oil check, and water hookup.
Purging air, selecting nozzles, turning on water.
Instructions for engine ignition and initiating water spray.
Steps for safe shutdown, including chemical rinse and pressure release.
Engine checks, pump care, and connection maintenance.
Procedures for cleaning spray nozzles and water inlet filters.
Fuel stabilization and pump protection for storage.
Draining water, securing components for storage.
Guidelines for accessories and model technical data.
Details on 90-day component and 2-year pump/frame warranties.
Engine warranty handling and user's care duties.
Conditions and damages not covered by warranty.
Common causes and solutions for engine not starting.
Troubleshooting steps for low pressure on first use.
Problems with drawing chemicals or maintaining pressure.
Diagnosing and fixing leaks and pump pulsation.
