Stanley SXPW2823 - QUICK START GUIDE; Release System Air; Set Engine Controls for Starting; Start the Engine

10- ENG
7
Release Air
from System
Release all
air from pump and
high pressure hose by
depressing trigger until a
steady stream of water is
present. Approximately
30seconds.
8
Verify the
Engine Switch
is turned to the
ON Position
9
Move the
Choke to the
CHOKE
Position
10
Pull the Recoil
Starter Grip
Pull the
recoil starter grip to
start theengine.
11
Move the
Choke to the
RUN Position
Gradually move the
Choke to the RUN Position
after enginestarts.
DANGER: This Guide is not a substitute for reading the operator's manual. User must
read and understand operator's manual before using thisproduct.
Job Name: 31925 FNA STANLEY 7108823 MANUAL
PDF Page: SXPW3124_2823 pw manual 7108823 rev 0 03142017.p10.pdf
Process Plan : Tabloid Pdf Proof HI-RES - NO TRIM LINES
Date: 17-03-14
Time: 14:59:44
Operator: ____________________________
PageMark-BW-Comp
❏ OK to proceed
❏ Make corrections and proceed
❏ Make corrections and show another proof
Signed: ___________________ Date: ______
Job Name: 31925 FNA STANLEY 7108823 MANUAL
PDF Page: SXPW3124_2823 pw manual 7108823 rev 0 03142017_DBL.p10.pdf
Process Plan : Tabloid Pdf Proof HI-RES With TRIM LINES
Date: 17-03-14
Time: 15:03:14
Operator: ____________________________
PageMark-BW-Comp
❏ OK to proceed
❏ Make corrections and proceed
❏ Make corrections and show another proof
Signed: ___________________ Date: ______