Stanley SXPW22E User Manual (English)

Questions and Answers:

K
Kevin BerryAug 4, 2025
Why Stanley Pressure Washer pump does not reach working pressure?
- L
  lukeryanAug 4, 2025
  The Stanley Pressure Washer pump might not be reaching working pressure due to several reasons. It could be a worn nozzle, which would require replacement. The water filter might be dirty and needs cleaning. Ensure the water supply tap is fully open to provide sufficient water. Air being sucked into the system or trapped in the pump can also cause this issue; check the tightness of hose fittings and try depressing/releasing the gun trigger until the water flow is steady. Also, verify the adjustable nozzle is correctly positioned and the suction height is not more than 0.5 m. In some cases, the thermostatic valve may have tripped, requiring you to wait for the correct water temperature to be restored.
E
Elizabeth GriffinAug 9, 2025
What to do if Stanley SXPW22E motor 'buzzes' but fails to start?
- L
  Lindsey HendrixAug 9, 2025
  If the Stanley Pressure Washer motor buzzes but doesn't start, the power supply voltage may be too low. Check that the voltage of the mains power supply line is the same as indicated on the appliance's plate. Also, a voltage drop might occur due to the use of an extension cable; verify the characteristics of the extension cable.
A
Anthony BowersAug 12, 2025
What to do if Stanley Pressure Washer pump pressure drops during sudden use?
- G
  gibsonjohnAug 13, 2025
  If the Stanley Pressure Washer's pump pressure drops suddenly, it could be because water is being drawn from an external tank; try connecting the appliance to the mains water supply. The inlet water might be too hot, so reduce the temperature. Additionally, the nozzle or inlet filter may be clogged, requiring you to clean them.
C
Christopher KleinAug 17, 2025
How to fix Stanley Pressure Washer motor that fails to start?
- N
  ncarterAug 17, 2025
  If the Stanley Pressure Washer motor fails to start, first check that the plug is firmly in the socket and that the mains voltage supply is present. If the issue persists and your model has this feature, use the tool to unjam the motor through the hole at the rear of the appliance.
S
Shirley GriffinAug 21, 2025
Why Stanley SXPW22E has no detergent sucked in?
- S
  Stephen PriceAug 21, 2025
  If the Stanley Pressure Washer is not sucking in detergent, make sure the adjustable nozzle is not on the high-pressure setting; set it to the appropriate setting. The detergent might be too dense, so dilute it with water. If you're using a high-pressure hose extension, fit the original hose instead.
G
George ThompsonAug 26, 2025
Stanley SXPW22E (TSS versions only) no water delivery when gun trigger is depressed, what to do?
- R
  Richard HooverAug 27, 2025
  If there is no water delivery when the gun trigger is depressed on your Stanley Pressure Washer (TSS versions only), the nozzle might be clogged. Clean the nozzle.
J
jonesmichaelAug 29, 2025
Why water escapes from thermostat valve of Stanley SXPW22E Pressure Washer?
- A
  Annette WilliamsAug 30, 2025
  Water may escape from the thermostat valve of your Stanley Pressure Washer if the water temperature inside the pump head has exceeded the maximum rated value stated on the nameplate. To prevent this, with the appliance in operation, do not stop the water jet for more than 5 minutes at a time.