6
ENGLISH
d )  When not in use, store the machine out of the reach 
ofchildren.
e )  Use blade cover for metal blades during transport 
andstorage.
f )  Clean before storing, including the use of guards on 
cutting attachments with metalblades.
ADDITIONAL SAFETY INSTRUCTIONS FOR 
GRASS TRIMMERS
 
WARNING: Cutting elements continue to 
rotate after the motor is switchedoff.
•  Wear long trousers to protect yourlegs.
•  Before using the appliance, check that your cutting path is free 
from sticks, stones, wire and any otherobstacles.
•  Only use the appliance in the upright position, with the cutting 
line near the ground. Never switch the appliance on in any 
otherposition.
•  Move slowly when using the appliance. Be aware that freshly 
cut grass is damp andslippery.
•  Do not work on steep slopes. Work across the face of slopes, 
not up anddown.
•  Never cross gravel paths or roads while the appliance 
isrunning.
•  Never touch the cutting line while the appliance isrunning.
•  Do not put the appliance down until the cutting line has come 
to a completestandstill.
•  Use only the appropriate type of cutting line. Never use metal 
cutting line or fishingline.
•  Keep hands and feet away from the cutting line and blade at 
all times, especially when switching on themotor.
•  Before using the appliance and after any impact, check for 
signs of wear or damage and repair asnecessary.
•  Take care against injury from any device fitted for trimming 
the filament line length. After extending new cutter line always 
return the machine to its normal operating position before 
switchingon.
•  Close supervision is necessary when the appliance is used 
nearchildren.
•  This appliance is not intended for use by young or infirm 
persons withoutsupervision.
•  This appliance is not to be used as atoy.
•  Use in a dry location only. Do not allow the appliance to 
becomewet.
•  Do not immerse the appliance inwater.
•  Do not open the body casing. There are not user-serviceable 
parts inside
•  Do not operate the appliance in explosive atmospheres, such 
as in the presence of flammable liquids, gases ordust.
•  When the appliance is stored or transported in a vehicle 
it should be placed in the boot or restrained to prevent 
movement following sudden changes in speed ordirection.
•  When not in use, the appliance should be stored in a dry, well 
ventilated place out of reach ofchildren.
•  Children should not have access to storedappliances.
Safety of Others
•  This appliance is not intended for use by persons (including 
children) with reduced physical, sensory or mental capabilities, 
or lack of experience and knowledge, unless they have been 
given supervision or instruction concerning use of the appliance 
by a person responsible for theirsafety.
•  Children must be supervised to ensure that they do not play 
with theappliance.
Residual Risks
To ensure you have good footing on slopes, do not overreach. 
Keep your balance at all times. Always walk, do notrun.
Additional residual risks may arise when using the tool which 
may not be included in the enclosed safety warnings. These risks 
can arise from misuse, prolonged useetc.
Even with the application of the relevant safety regulations and 
the implementation of safety devices, certain residual risks can 
not be avoided. These include:
•  Injuries caused by touching any rotating/movingparts.
•  Injuries caused when changing any parts, blades 
oraccessories.
•  Injuries caused by prolonged use of a tool. When using any 
tool for prolonged periods ensure you take regularbreaks.
•  Impairment ofhearing.
•  Health hazards caused by breathing dust developed when 
using your tool (example: working with wood, especially oak, 
beech and MDF.)
Electrical Safety
The electric motor has been designed for one voltage only. 
Always check that the battery pack voltage corresponds to the 
voltage on the rating plate. Also make sure that the voltage of 
your charger corresponds to that of yourmains.
Your STANLEYFATMAX charger is double insulated 
in accordance with EN60335; therefore no earth wire 
isrequired.
 
WARNING: 115 V units have to be operated 
via a fail-safe isolating transformer with an earth screen 
between the primary and secondary winding.
If the supply cord is damaged, it must be replaced by a specially 
prepared cord available through the STANLEYFATMAX 
serviceorganisation.
Mains Plug Replacement 
(U.K. & Ireland Only)
If a new mains plug needs to be fitted:
•  Safely dispose of the oldplug.
•  Connect the brown lead to the live terminal in theplug.
•  Connect the blue lead to the neutralterminal.