3
GB
• ALWAYS use only accessories that are recommended by the manufacturer for you model. Accessories
• DO NOT remove or deface warning labels. Removing labels increases risk of laser radiation.
• DO NOT
result in serious injury.
• DO NOT direct the laser beam toward aircraft or moving vehicles.
• DO NOT
• DO NOT splash or immerse the unit in water.
• ALWAYS turn off the product when not in use.
• ALWAYS ensure battery is inserted in the correct manner, with the correct polarity.
• NEVER intentionally short any battery terminals.
• DO NOT attempt to charge alkaline batteries.
• DO NOT
• ALWAYS
• DO NOT dispose of this product with household waste.
• ALWAYS check local codes and properly dispose of used batteries.
• PLEASE RECYCLE in line with local provisions for the collection and disposal of electrical and electronic
waste.
WARNING: Carefully read the User Safety and Operating Instructions before using this
product. The person responsible for the instrument must ensure that all users understand and adhere to
these instructions.
WARNING: The following labels are placed on the laser tool to inform you of the laser class for your
convenience and safety.
The IntelliLaser
TM
Pro
OPERATING INSTRUCTIONS
BATTERY
battery indicator is on.
USAGE
Detecting Wood / Metal Studs
Note: Laser line is always on when holding the activation button.
1) Hold the IntelliLaser
TM
Pro
button
Note: The unit cannot be moved before calibration is complete.
• Keep holding the activation button during all of the following procedures.
Note: Once the activation button is released, the unit shuts off.
Note:Laser
TM
Pro
• Slide the IntelliLaser
TM
Pro
2)
the laser line emanating from the top of the unit to mark the stud edge.
3-4) Repeat the above steps from the other side of the stud. Coming from the opposite direction, mark the
other edge of the stud.
• The midpoint of the two marks indicates the stud center.
IEC60825-1: 2014
To Next Page
Loading...
