4
GB
User Manual
Detecting Live Wires
will illuminate and the IntelliLaser
TM
Pro sounds an audible tone, warning
Warning:
Warning:
situations the voltage detection option may not accurately indicate the presence of voltage in the
event of internal device failure or improper operation, and therefore should not be relied upon for
Always turn off AC power when working near wiring.
Always
condition prior to commencing work.
Note: Static electrical charges that can develop on drywall and other surfaces will spread the voltage
detection area many inches on each side of the actual electrical wire. To aid in locating the wire position,
Warning: Shielded wires or wires in metal conduits, casings, metalized walls or thick, dense walls will
not be detected.
Cautions on Operating
Always
the power.
Laser Leveling/Line Generation
pressing the laser plane lock/release button.
orientation.
Mounting Hole and Push Pins
Two push pins are stored at the bottom part of IntelliLaser
TM
Pro. They are used to mount the IntelliLaser
TM
Pro
OPERATING TIPS
Conventional Construction
IntelliLaser
TM
Pro detects the edge of these double studs and solid headers and emits and holds an audio
signal as it crosses over them.
Surface Differences
The IntelliLaser
TM
Pro will scan through common building materials, Including:
• Linoleum over wood
The sensor cannot scan through:
• Carpeting
• Foil faced materials
• Ceramic tile
• Cement or concrete
• Metal & plaster walls
To Next Page
Loading...
