Stanley SPL3 - Set Up; Laser Tool Placement; Mounting on Accessories; Operation

10
STHT77342
Set Up
Laser Tool
• Placelasertoolonaat,stablesurface.
• Ifusingtheautolevelingfeaturemovethependulum/
transportlocktotheunlockedposition.Thelasertool
mustthenbepositionedinitsuprightpositionona
surfacethatiswithinthespeciedcompensationrange.
• Thelasertoolcanbeplacedinanyorientationandbe
functionalonlywhenthependulum/transportlockisin
thelockedposition.
Mounting on Accessories
• Positionaccessoryinaplacewhereitwillnotbeeasily
disturbedandnearthecentrallocationoftheareato
bemeasured.
• Setuptheaccessoryasrequired.Adjustpositioningto
besureaccessorybaseisnearhorizontal(withinlaser
toolscompensationrange).
• Mountthelasertooltotheaccessoryusingthe
appropriatefasteningmethodtobeusedwithsuch
accessory/lasertoolcombination.
CAUTION:
• Donotleavethelasertoolunattendedonan
accessorywithoutfullytighteningthefastening
screw.Failingtodosomayleadtothelasertool
fallingandsustainingpossibledamage.
NOTE:
• Itisbestpracticetoalwayssupportlasertoolwith
onehandwhenplacingorremovinglasertoolfroman
accessory.
• Ifpositioningoveratarget,partiallytightenthefastener,
alignlasertool,andthenfullytighten.
Operation
NOTE:
• SeeLEDDescriptionsforindicationsduringoperation.
• Beforeoperatingthelasertoolalwaysbesuretocheckthe
lasertoolforaccuracy.
• InManualMode,Self-LevelingisOFF.Theaccuracyofthe
beamisnotguaranteedtobelevel.
• Lasertoolwillindicatewhenitisoutofcompensation
range.ReferenceLEDDescriptions.Repositionlasertoolto
beclosertolevel.
• Whennotinuse,pleasebesuretopowerOFFthelaser
toolandplacethependulumlockinthelockedposition.
Power
• Movethepowerswitch(SeegureC)totheunlocked
positiontoturnthelasertoolON.
• ToturnthelasertoolOFF,movethepowerswitch(See
gureC)tothelockedposition.
Mode
• Allbeamsareactivatedwhentheunitispoweredon.
Self-Leveling (See figure
C
)
•
Whenthependulumlockonthelasertoolis
switchedtotheon/unlockedpositiontheunitisin
self-levelingmode.
Applications
Plumb / Point Transfer
• Establish2referencepointsthatneedtobeplumb.
• Aligneitherthedownlaserbeamortheuplaserbeamtoa
setreferencepoint.
• Theopposinglaserbeam(s)willbeprojectingapointwhich
isplumb.
• Positionthedesiredobjectuntilthelaserbeamisaligned
withthesecondreferencepointthatneedstobeplumb
withthesetreferencepoint.
Level / Point Transfer
• Usefrontlaserbeamtoprojectlevelreferencepointout
todesiredobject.
• Establish2referencepointsthatneedtobelevel.
• Alignthefrontbeamlasertoasetreferencepoint.
• Withatripodorotherstationaryobject,rotatethelaser