© 2021 Pinnacle Climate Technologies, Inc.
NEVER LEAVE HEATER UNATTENDED WHILE BURNING OR
WHILE CONNECTED TO A POWER SOURCE
Assembly
1. Slide axle through Wheel Frame and attach
wheels, washers and nuts.
2. Place main structure on wheel frame and
fasten with long screws provided.
3. Attach safety guard to front of heater with
screws provided.
4. Attach Radiant Visors to the top and bottom
rear of the Radiant Cone Assembly using extra
screws included.
5. Attach top safety guard using the two
outer-most extra screws on the top of the
radiant cone (See photo).
Note: Save the box and packaging materials for
future storage.
Screws
Radiant
Cone
Assembly
Safety
Guard
Radiant Visor
7
To Next Page
Loading...
