EasyManua.ls Logo

Stanley ST-70TW-KFA-E - User Manual

Stanley ST-70TW-KFA-E
65 pages
Save Page as PDF
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
ST-45-KFA-E / ST-70T-KFA-E /ST-70TW-KFA-E /
ST-125T-KFA-E / ST-175T-KFA-E / ST-215T-KFA-E
NEVER LEAVE HEATER UNATTENDED WHILE BURNING, OR WHILE
CONNECTED TO A POWER SOURCE.
THIS PRODUCT IS NOT SUITABLE FOR PRIMARY HEATING PURPOSES.
STKB-430

Table of Contents

Questions and Answers

  • E
    Elaine HumphreySep 9, 2025
    What to do if Stanley ST-70TW-KFA-E Heater won't turn on?
    • R
      Rebecca StoneSep 9, 2025
      If your Stanley Heater doesn't turn on and the lamp isn't lit, the temperature limit sensor may have overheated; turn the power switch off and let the heater cool for 10 minutes before turning it back on. Check the power cord and extension cord to ensure a proper connection and test the power supply. Also, the fuse might be blown, so check and replace it if necessary. Inspect all electrical connections between the Temperature Limit Sensor and the Circuit Board.
  • H
    Haley HullSep 12, 2025
    Why Stanley ST-70TW-KFA-E fan is not working?
    • S
      Sean VillarrealSep 12, 2025
      If the fan on your Stanley Heater isn't working when plugged in and the power switch is on, with the lamp flickering or the LED showing 'E1' or 'E2', the thermostat might be set too low (except for model ST-45-KFA-E); rotate the thermostat to a higher setting. Also, there could be a broken electrical connection between the Main PCB and the motor; inspect all electrical connections.
  • M
    Mrs. Abigail FisherSep 14, 2025
    What to do if Stanley Heater lamp flickers and shows E3?
    • J
      James GordonSep 14, 2025
      If the lamp on your Stanley Heater is flickering and the LED display shows 'E3', it indicates that the thermostat switch has failed and needs to be replaced.
  • J
    johnturnerSep 16, 2025
    How to fix Stanley ST-70TW-KFA-E Heater when lamp flickers and shows “E3”?
    • M
      Miranda AdamsSep 16, 2025
      If the lamp is flickering and the LED display shows “E3” on your Stanley Heater, it means that the thermostat switch has failed. Replace the thermostat switch.

Stanley ST-70TW-KFA-E Specifications

General IconGeneral
Voltage220-240 V
Frequency50 Hz
Heating TechnologyCeramic
Adjustable ThermostatYes
Overheat ProtectionYes
Tip-Over ProtectionYes
OscillationYes
Remote ControlYes
TimerYes
Heater TypeTower
Power SourceElectric

Related product manuals