Stanley ST4WPLT-(CA) - Pump Water Capacity Check

Pre-Operating Instructions: Air Cleaner Element Check
NOTICE:
•DoNOTrunenginewithoutwaterinsidethepump.Operationofenginewithoutwaterinsidethe
pump will cause the pump to overheat. Prolonged operation of engine without water inside the pump
will damage the pump gasket and impeller.
•Ifwaterwithinthepumpisnotfull,shutofftheengineatonceandfillthepumpafterallowingthe
unit to cool.
To Check Pump Water:
1. Remove water filler cap.
2.Visuallycheckforwaterinsidepump.
3. If too low, add water through water filler hole.
4. Securely re-fasten water filler cap.
PRIME PUMP BEFORE USE!
15