ENGLISH • 19
f Regularly use the soft brush or dry cloth to clean the
ventilation slot of the equipment / tools / charger.
f Regularly use a damp cloth to clean the motor
housing. Please do not use any abrasive cleaning
agents or solvent-based cleansing agents.
f Regularly open the clamping chuck and tap it gently to
remove any internal dust (after installation).
CLEANING
Warning! Once the visible dust build-up is found at
and/or around the ventilating ports, immediately flush
the dust and powder within the host shell with clean dry
air. To perform this procedure, wear the approved safety
equipment and dust mask.
ACCESSORIES
The performance of your tool depends on the accessory
used. STANLEY accessories are engineered to
high quality standards and designed to enhance the
performance of your tool. By using these accessories you
will get the very best from your tool.
PROTECTING THE ENVIRONMENT
Separate collection. This product must not be
disposed of with normal household waste.
Should you find one day that your STANLEY
product needs replacement, or if it is of no further
use to you, do not dispose of it with household
waste. Make this product available for separate
collection.
Separate collection of used products and packaging
allows materials to be recycled and used again.
Re-use of recycled materials helps prevent
environmental pollution and reduces the demand
for raw materials. Local regulations may provide for
separate collection of electrical products from the
household, at municipal waste sites or by the
retailer when you purchase a new product.
SERVICE INFORMATION
STANLEY offers a full network of company-owned and
authorized service locations. All STANLEY Service
Centers are staffed with trained personnel to provide
customers with efficient and reliable power tool service.
For more information about our authorized service
centers and if you need technical advice, repair,
or genuine factory replacement parts, contact the
STANLEY location nearest you.
SPECIFICATIONS STDH8013
Voltage
AR 220V~ 50Hz
B2C 220V~ 50-60Hz
B3 120V~ 60Hz
B2 220V~ 60Hz
BR 127V~ 60Hz
Power 720W
No-load speed 0 - 3000/min (0-2900 TW)
Impact 54000 ipm (52200 TW)
Reverse/Forward rotation Yes
Chuck capacity 1,5 - 1,3mm
Max capacity
Concrete 16mm
Metal 13mm
Wood 32mm
Weight 2,5kg
To Next Page
Loading...
