Why Stanley Drill unit will not start?
If your Stanley Drill unit isn't starting, it could be due to a couple of reasons. First, check the battery pack installation to ensure it is properly installed. Second, the battery pack may not be charged, so check the battery pack charging requirements.
What to do if Stanley FatMax V20 SFMCD711 Drill starts immediately upon inserting battery?
If your Stanley Drill starts immediately upon inserting the battery, the switch has likely been left in the “on” position. To prevent this, move the switch to the “off” position before inserting the battery.
Why does my Stanley FatMax V20 SFMCD711 unit shut off abruptly?
Your Stanley Drill might be shutting off abruptly because the battery pack has reached its maximum thermal limit. If this is the case, allow the battery pack to cool down. Alternatively, the battery pack may be out of charge; place it on the charger and allow it to charge.
What to do if Stanley Drill battery pack will not charge?
If your Stanley Drill battery pack won't charge, there are a few potential reasons. First, ensure the battery pack is fully inserted into the charger until the LED lights illuminate. Also, verify that the charger is plugged into a working outlet. Lastly, the surrounding air temperature might be too hot or too cold. Move the charger and battery pack to an area where the surrounding air temperature is above 40 degrees F (4.5ºC) or below 105 degrees F (+40.5ºC).
Read all safety warnings, instructions, and specifications provided with this power tool.
Provides extra safety warnings specific to screwdrivers and impact drilling.
Describes potential risks that remain even with safety measures.
General| Voltage | 20V |
|---|---|
| Chuck Size | 1/2 inch |
| Speed Settings | 2 |
| Power Source | Cordless |
| Number of Gears | 2 |
| Battery Type | Lithium-Ion |
| Battery System | Stanley FatMax V20 |
| Battery Capacity | 2.0 Ah |
To Next Page
