11
(Original instructions)
EN © 2016 English
EN
3.2.11 WARNING. COMPLY WITH the local water supply authority regulations. Under IEC
60335-2-79, the appliance may only be connected to the mains drinking water
supply if the supply hose is fitted with a backflow preventer valve with drain
facility corresponding to EN 12729 type BA. The backflow preventer can be
ordered from the manufacturer.
3.2.12
WARNING. Water that has passed through backflow preventers is considered to be non-potable.
3.2.13 WARNING. Maintenance and/or repair of electrical components MUST be carried
out by qualified staff.
3.2.14
WARNING. DISCHARGE residual pressure before disconnecting the hose from the appliance.
3.2.15 WARNING. CHECK before each use and at regular intervals that the screws are fully
tightened and that there are no broken or worn parts.
3.2.16 W
ARNING. ONLY USE detergents which will not corrode the coating materials of
the high pressure hose / electric cable.
3.2.17 W
ARNING. ENSURE that all people or animals keep a minimum distance of 16 yd.
(15m) away.
3.2.18 W
ARNING. This appliance is designed for use with the detergent supplied or
recommended by the manufacturer. The use of other detergents or chemicals
may adversely affect the appliance’s safety.
3.2.19 W
ARNING. Do not allow the detergent to come into contact with the skin, and the
eyes in particular! In case of contact with eyes, rinse with plenty of water and
seek medical advice at once!
3.2.20 W
ARNING. High pressure hoses, fittings and joints are important for the appliance’s
safety. Use only hoses, fittings and joints recommended by the manufacturer.
3.2.21 W
ARNING. To ensure the appliance’s safety, only use the manufacturer’s genuine
parts, or other parts which carry its approval.
3.2.22 W
ARNING. Unsuitable extension cables can be dangerous. If an extension cable is
used, it must be suitable for outdoor use, and the connection must be kept dry
and off the ground. Use of a power cable reel which keeps the socket at least 60
mm above the ground is strongly recommended.
3.2.23 W
ARNING. Switch the appliance off and disconnect it from the power supply before
assembly, cleaning, adjustments, maintenance, storage and transportation.
3.2.24 W
ARNING. Insert the pipe jet kit down to the red mark before turning the
appliance on.
To Next Page
Loading...
