Stanley T14 - Badge Management; Configuring and Updating Badges

T14 Patient and Staff Badges
User Guide 13
Badge Management
Configuring and Updating Badges
T14 Badges must be initially configured using the TMBD application (Tag
Manager Bi-Directional application which is part of the Hardware Manager
application) before use. The TMBD application allows you to activate and
configure the following badge parameters according to a sites infrastructure
and use case.
• Transmission and IP Settings:
 Wireless LAN Infrastructure
 Network Access Information
 MobileView IP Settings
• Badge Configuration:
 The badge firmware contains 30 pre-defined configurations. These
configurations define the badge type, beacon rate and ultrasound
infrastructure behavior. Each configuration has a unique ID number
called a “Static Configuration” which cannot be edited. Only 1 (one)
configuration can be selected and used for the badge.
Once the badges have been initially configured using the TMBD application,
future configurations can then be done wirelessly via MobileView.
The following tables show the available configurations according to the Badge
Firmware. For more information please refer to Bi-directional Tags
Configuration Details document (KB Article 7826).
Firmware 1.25.xx
Config ID Badge Type Ultrasound Infrastructure Beacon Rate
123 Patient Gen1 30sec
124 Patient Gen1 60sec
125 Patient Gen1 120sec
126 Patient Gen1 5min
127 Transported Patient Gen1 30sec
128 Transported Patient Gen1 60sec
129 Transported Patient Gen1 120sec
130 Transported Patient Gen1 5min
131 Patient Gen2 30sec
132 Patient Gen2 60sec