Stanley T14 - Page 23

T14 Patient and Staff Badges
User Guide 22
EMC Information
Table 1
The TAG1410 is intended for use in the electromagnetic environment specified below.
The customer or the user of the TAG1410 should assure that it is used in such an
environment.
Emissions test
Compliance
Electromagnetic environment – guidance
RF emissions CISPR
11
Group 1
The TAG1410 uses RF energy only for its
internal function. Therefore, its RF emissions
are very low and are not likely to cause any
interference in nearby electronic equipment.
RF emissions CISPR
11
Class B
The TAG1410 is suitable for use in all
establishments, including domestic
establishments and those directly connected to
the public low voltage power supply network
that supplies buildings used for domestic
purposes.
Harmonic emissions
IEC 61000-3-2
Not Applicable
Voltage
fluctuations/
flicker emissions
IEC 61000-3-3
Not Applicable
Table 2
The TAG1410 is intended for use in the electromagnetic environment specified below.
The customer or the user of the TAG1410 should assure that it is used in such an
environment.
Immunity Test
IEC 60601 Test
Level
Compliance level
Electromagnetic
environment – guidance
Electrostatic
discharge (ESD) IEC
61000-4-2
± 8 kV contact
± 2 kV, ± 4 kV,
± 8 kV, ± 15 kV
air
± 8 kV contact
± 2 kV, ± 4 kV,
± 8 kV, ± 15 kV
air
Floors should be wood,
concrete or ceramic tile. If
floors are covered with
synthetic material, the
relative humidity should
be at least 30 %.
Electrical fast
transient/burst
IEC 61000-4-4
Not Applicable Not Applicable
Surge
IEC 61000-4-5
Not Applicable Not Applicable