To Next PageTo Next PageWhy does my Stanley Tara fire go out?
If the fire in your Stanley Boiler goes out, it might be due to air starvation or insufficient draught. To resolve this, open the lower spin wheel and top air control lever. Also, check the flue for any obstructions and sweep it if necessary. It is recommended to seek advice from a chimney specialist.
What to do if Stanley Tara smokes when lighting up?
If your Stanley Boiler smokes when lighting up, it's likely because the flue duct is cold. To fix this, burn paper and kindling to increase the heat.
How to stop Stanley Tara Boiler fire burning too quickly?
If the fire in your Stanley Boiler burns too quickly, it could be due to too much draught or poor quality wood/fuel. Make sure the lower spin wheel is closed and partially close the top air control lever. Avoid continuously burning small wood, sticks, bundles, or carpentry off-cuts like plywood or pallets.
What to do if Stanley Tara smokes while burning?
If your Stanley Boiler smokes while burning, it could be due to insufficient draught, down draught, or the room being in decompression. Consult a chimney specialist. Check that the flue is not obstructed, sweep if necessary. Consider installing an anti-down draught cowl. Consult your dealer. If you have Mechanical Ventilation, make sure an outside air intake is installed for the chimney.
Why is my Stanley Tara Boiler giving low heat output?
If your Stanley Boiler is giving low heat output, it is likely due to the use of incorrect fuels. Use the recommended fuel.
How to fix Stanley Tara Boiler fire difficult to start?
If the fire in your Stanley Boiler is difficult to start, it might be because of unseasoned, damp, or poor-quality wood, or logs that are too big. Use only the recommended fuel. To light the fire, use small, very dry twigs, and to maintain the fire, use split logs.
What causes excessive condensation on the Stanley Tara Boiler?
Excessive condensation on your Stanley Boiler can be caused by cold water being circulated or fuel with excessive moisture content. Check that the pipe thermostat is fitted and set correctly. Season fuel to achieve lower moisture content.
Why does Stanley Tara fire shuts down after a period of time?
If the fire in your Stanley Boiler shuts down after a period of time, it may be due to insufficient water circulation through the boiler. In this case, check the plumbing.
General