5
E
Specifications
Range 7in to 30ft (17.5cm to 9m)
Measuring Accuracy* Typically ± 1/4in (± 6mm)*
Resolution** 1/16in (1mm)**
Laser Class Class 2 (IEC/EN60825-1: 2014)
Laser Wavelength ≤ 1.0mW @ 620-690nm
Auto Power Switch-off After 45s
Battery Life Up to 3000 Measurements
or 30 days (if the tool is not used)
Dimension (H x D x W) 2.44 x .69 x 1.25in (62 x 17.5 x 32mm)
Weight
1.12oz (31.75g)
Storage Temperature Range
14° F ~ 140° F (-10° C ~ +60 C)
Operating Temperature Range
32° F ~ 104° F (0° C ~ +40° C)
*
Measuring Accuracy depends on the current conditions. Under favorable conditions (good target surface and room temperature)
up to 30ft (9m).
**Resolution is the nest measurement you can see. In inches, that is 1/16". In mm, that is 1mm.
Warranty
STANLEY warrants this product for a period of (2) years against deficiencies in material and workmanship. This
LIMITED WARRANTY does not cover products that are improperly used, abused, altered, or repaired. Please call
866-786-5924 for more information or return instructions. Unless otherwise noted, STANLEY will repair without cost,
any STANLEY product found to be defective, including parts and labor charges, or at STANLEY’s option, will replace
such tools or refund the purchase price, less the amount for depreciation, in exchange for the defective tool. THIS
LIMITED WARRANTY EXCLUDES ALL INCIDENTAL OR CONSEQUENTIAL DAMAGES. Some states do not
allow the exclusion or limitation of incidental or consequential damages, so these limitations may not apply to you.
This LIMITED LIFETIME WARRANTY gives you specific legal rights that may vary from state to state. In addition to
the warranty, STANLEY Lasers are covered by: 30-Day Money Back Guarantee. If you are not completely satisfied
with the performance of your STANLEY Laser for any reason, you can return it within 30 days from the date of
purchase with a receipt for a full refund.
IMPORTANT NOTE: The customer is responsible for the correct use and care of the instrument. Moreover, the
customer is completely responsible for periodically checking the accuracy of the laser unit, and therefore for the
calibration of the instrument.
Calibration and care are not covered by warranty.
To Next Page
Loading...
