Stanley TLM30 - Error Codes; Troubleshooting Error Codes

6
E
Error Codes
Code Description Corrective Action
--- Received Signal Too Weak or
Measuring Time Too Long
Use a target plate or change the target surface.
--- Received Signal Too High The target is too reective. Use a target plate or change the
target surface.
--- Too Much Background Light Reduce the background light on the target area.
--- Laser Beam Interrupted Remove any obstacles in the path of the laser beam and repeat
the measurement.
--- Insufcient Battery Recharge the tool's battery.
301 Temperature Too High Allow the tool to cool down to a temperature within the specied
Operating Temperature Range.
Temperature Too Low Allow the tool to warm up to a temperature within the specied
Operating Temperature Range.
401 Hardware Error Switch the tool on and off several times. If the hardware error
still does not clear, return it to a Service Center or distributor.