Need help?Do you have a question about the Stanley TLM165s and is the answer not in the manual?
General| Accuracy | ±1.5 mm |
|---|---|
| Units of Measurement | Meters, Inches, Feet |
| Battery Type | 2 x AAA |
| Laser Class | Class 2 |
| Laser Diode | 635 nm, <1 mW |
| Dust and Splash Protection | IP54 |
| Resolution | 0.001 m |
| Measuring Range | 0.05 to 50 m |
| Display | LCD |
| Weight | 100 g (with batteries) |
| Operating Temperature | 0°C to 40°C |
| Functions | Area, Volume, Pythagoras |
Measure the distance from the tool to a wall or object.
Take a series of measurements as you move around.
Measure the area of a wall, floor, or object.
Measure the volume of a room or object.
Calculate the height based on distances to 2 or 3 points on the object.
Add two measurements to get a total measurement.
Subtract one measurement from another.
Set the unit of measure to fractional ft, inches, decimal ft, or meters.
Pair the tool with the STANLEY Smart Connect application for floor plans.
Turn off the beeps that occur each time a measurement is taken.
To Next Page