8
SIGN REPLACEMENT
1. Unplug cord from the receptacle.
2. Push front plastic panel up using a plastic pin or very small screwdriver.
3. Pull forward on the bottom edge of the plastic panel and remove it.
4. Replace the sign.
5. Place the front plastic panel back into its original position.
LIGHT BULB REPLACEMENT
1. Unplug cord from the receptacle.
2. Remove both front panels as stated above.
3. Replace bulbs with a 10 or 15 watt candelabra base for 120V or a 10 watt
medium base for 240V.
MAINTENANCE AND REPAIRS
Contact the factory, a service representative or a local service company for service or required main-
tenance.
To Next Page
Loading...
