3
Specications
Model Capacity
Electrical Deminsions
Wieght
Voltage Hz Phase Watts Amps Depth Width Hieght
4RW-P
3.5 qt
120V 60
1 PH
600W
5 Amp 14.625”
8.75” 16.375” 7.5 lbs
4RW-P 240VE 50/60 2.5 Amp 19.625”
4RW-L
4 qt
120V 60 5 Amp
8.75”
13.625” 7 lbs
4RW-L 240VE 50/60 2.5 Amp
4RW 120V 60 5 Amp
9.875” 6 lbs.
4RW 240VE 50/60 2.5 Amp
7RW-7H
7 qt
120V 60
1100W
9.2 Amp
9.5”
12.625” 10 lbs
7RW
9.125” 8 lbs
7RW 240V 50/60 4.6 Amp
11RW-P
11 qt
120V
60
1600W
13.3 Amp
16.625”
11.875”
15.5” 15 lbs.11RW-P 120C 11.875”
11RW-P 240V 50/60 6.7 Amp 11.875”
11RW-11H
120V
60
13.3 Amp 11.875”
12.375” 13 lbs
11RW
9.125” 10 lbs11RW 120C
11RW 240VE 50/60
This equipment is designed and sold for commercial use only by personnel trained and experienced in
its operation and is not sold for consumer use in and around the home nor for use directly by the general
public in food service locations.
INSTALLATION
These food warmers are equipped for the voltage and wattage indicated on the nameplate mounted to the
bottom panel and are designed for use on alternating current (AC) only.
DO NOT CONNECT TO DIRECT CURRENT (DC).
GENERAL OPERATING INSTRUCTIONS
4RW, 4RW-P, 7RW and 11RW
These warmers are designed to use stainless steel serving bowls purchased as an
option.
Follow these steps for setting up the warmer:
1. Before using warmer clean the warmer bowl and any accessories furnished with warmer or purchased
as an option..
2. Fill the warmer bowl according to the table below. Add water as required to maintain the proper water
level.
Model Ounces Liters
4RW/4RW-P 42 1.25
7RW 36 1.1
11RW 40 1.2
3. Place precooked food into a standard inset or optional stainless steel serving bowl and insert
into water bowl.
4.
Turn warmer on.
5. If preheating is desired set the control to the "HI" position for approximately 25 minutes.
Prolonged "HI" setting may result in overcooking or scorching of certain foods.
CAUTION
WARNING
To Next Page
Loading...
Need help?
General
