EasyManua.ls Logo

Star Pro-Max GR14SPT - General Installation and Operation; General Installation Data; Installation Instructions; Initial Start Up and Presets

Star Pro-Max GR14SPT
12 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
3
GENERAL INSTALLATION DATA
CAUTION
This equipment is designed and sold for commercial use only by personnel trained and
experienced in its operation and is not sold for consumer use in and around the home nor for
use directly by the general public in food service locations.
INSTALLATION
1. Plug unit into dedicated 240 V.A.C. line with 15AMP receptacle.
2. DO NOT plug into 120V line. Doing so will damage the unit and void the warranty.
3. Each machine has been properly wired and inspected at the factory for operation on the
voltageandtypeofcurrentspeciedonthenameplate.
CAUTION
DO NOT CONNECT TO ANY TYPE OF CURRENT OTHER THAN 240 V.A.C. OR THE
MACHINE WILL BE SERIOUSLY DAMAGED.
INITIAL START UP
Beforeusingtheunitforthersttime,cleanandheatforapproximately45minutes.
DO NOT ADJUST TIME AND TEMPERATURE
Theunittimeandtemperatureispresetbythefactorytothespeciccustomerrequirements
foratbread,burritos,quesadillasandcleaning.
The preset time and temperatures are:
Left Display:
Button Number Time Temperature
1 15sec. 505°F
2 27sec. 505°F
3 35sec. 505°F
4 (Cleaning) 00sec. 275°F
Right Display:
Button Number Time Temperature
1 15sec. Same as Left
2 27sec. Same as Left
3 35sec. Same as Left
4 00sec. Same as Left
Ifadjustmentsarerequiredforadditionalfoodproducts,pleaserefertothetimeor
temperature programming section in this manual.
OPERATING INSTRUCTIONS
1. Turnunitonbyplacingswitchin"ON"position.The"HeatOn"indicator,program
numberanddisplaywillashindicatingunitisheating.Whenthepresettemperatureis
reached,theheatinglight,displayandprogramlightindicatorwillstopashingfollowed
by 3 beeps. (Initial startup heating time is approximately 30 minutes).
2 Place product on the bottom cooking surface of the unit and close the lids.
3. Press program button and let displayed time count down to "0" at which time unit will
beep.Toturnoffthebeeper,pressprogrambuttonagain.
4. Raiselidsuntilitengagesintorstdetentandremovefood.Usingspatula,scrape
residue into grease catcher tray.
Note:Metalutensilsmaybeused,however,usingnonmetalutensilswillprolongthelife
of the cooking surface.
5. Turn the unit off when not in use.

Related product manuals