Star SM-T300 - Memory Switch Settings; Configuring Memory Switches

- 13 -
u
Press FEED button one time.
g
You will see present STOP BIT mode in the LCD.
Parity Bit
g
Stop Bit
g
Press the POWER button one time.
(The stop bit has set to 2 stop bit.)
1 Stop Bit
g
2 Stop Bit
u
Press FEED button one time.
g
You will see present DENSITY mode in the LCD.
Stop Bit
g
Density
g
Press the POWER button one time.
(The density has set to high.)
Density Medium
g
Density High
If all the mode have set, press the FEED button and the POWER button at the same
time after then release the buttons at the same time.
The printer will print out the mode status which has modied.
(RS-232C/9600 bps/7 Data bit/Even Parity/2 stop bit/Density High)
If the status is not correct, please try it again according to the procedure.