PLATE COMPACTOR
15
STORAGE
If the plate compactor will not be used for
a period longer than 30 days, following the
steps below to prepare your unit for storage.
Drain the fuel tank completely. Stored fuel
containing ethanol or MTBE can start to go
stale in 30 days. Stale fuel has high gum
content and can clog the carburetor and
restrict fuel flow.
Start the engine and allow it to run until
it stops. This ensures no fuel is left in the
carburetor. Run the engine until it stops.
This helps prevent deposits from forming
inside the carburetor and possible engine
damage.
While the engine is still warm, drain the oil
from the engine. Refill with fresh oil of the
grade recommended in the Engine Manual.
Allow the engine to cool. Remove the
spark plug and put 60 ml of SAE-30 of
high quality motor oil into the cylinder. Pull
the starter rope slowly to distribute the oil.
Replace the spark plug.
1.
2.
3.
4.
Use clean cloths to clean off the outside of
the compactor and to keep the air vents
free of obstructions.
5.
Remove the spark plug and drain all
of the oil from the cylinder before
attempting to start the unit after
storage.
Do not use strong detergents or
petroleum based cleaners when
cleaning plastic parts. Chemicals
can damage plastics.
Fold up the wheels bracket.5.
Carefully fold the handle down. Do not
allow control cables to become pinched or
bent.
Store your plate compactor in upright
position in a clean, dry building that has
good ventilation.
6.
7.
MAINTENANCE
To Next Page
Loading...
Need help?
General