Get Started
1
Launch Inspire X and insert batteries into
the hearing aids.
2
On the Get Started screen, select View
Programmers, then choose the 2.4 GHz
wireless programmer and select OK.
NOTE: Expected range for wireless
programming is 30 feet.
3
Select the check box next to the hearing aid(s)
to be programmed.
4
Select Read Device Settings to begin a new
fi tting or for a follow-up fi tting session using
the current settings in the hearing aids or Load
a Previous Session to retrieve a previously
saved session.
5
Select Start.
Initial Fit and Auto Path
Initial Fit launches automatically when programming new hearing aids.
1
Select the appropriate Acoustic Options,
then select OK.
2
Select the appropriate Experience with
Amplifi cation. [Fig. 1]
Refer to the Experience Manager QuickTIP
for additional information.
3
Insert hearing aids into the patient’s ears, reduce all
sources of noise, then select Begin to run the Auto Path.
NOTE: If hearing aid programming is conducted prior
to the fi tting appointment, re-run the Feedback Canceller
with the hearing aids in the patient’s ears.
3
Review the Auto Path results screen. Select Restart
if status is incomplete for any steps, or select Close
to continue.
Initial Fit Protocol
Figure 1
For 2.4 GHz Thrive platform RIC 312, Micro RIC 312 and BTE 13 hearing aids.
To Next Page
Need help?
General
