CONNECT TO NETWORK
WIRED MESH GUIDE
1. Set up your Starlink Kit as shown in the install instructions and ensure you are online.
2. Place your Starlink Router Mini in the desired location and connect the power supply.
3. Plug in an ethernet cable into the LAN port of the back of your existing Starlink router or Starlink Mini. For Gen 3 you will need to
remove the protective cover to access the ports.
4. Run the ethernet cable from the main router to your Starlink Router Mini. Connect to the WAN port of your router (Starlink symbol)
to create a wired mesh network.
5. Repeat with additional mesh nodes.
starlink.com/support
To Next Page
Loading...
