EasyManua.ls Logo

Starmix iPulse L-1635 - Permanent Filter Cleaning; Emptying the Container

Starmix iPulse L-1635
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
26 - en
* depending on model
NOTE
If the vacuum cleaner is not switched off, the re-start protection
remains effective. The vacuum cleaner is ready for operation only
after the unit has been switched off and switched on again.
▶ Remove the suction hose from the liquid before emptying.
▶ After switching off, a small quantity of water can ow back out of
the hose, as a result of the high suction level and the favourable
ow condition in the container.
▶ After wet vacuum cleaning insert dry lters for picking up dry
dust.
NOTE
When changing frequently between dry and wet vacuum
cleaning, use a second set of lters, preferably polyester folded
lter cartridges.
5.3 Sucking up asbestos-containing substances
Only vacuum cleaners of dust class H-asbestos may be used for
vacuuming asbestos-containing substances.
▶ Only work with a dry lter, vacuum cleaner and accessories to
prevent dust from sticking and becoming incrusted.
▶ For sucking up asbestos-containing substances: Insert the PE
emptying bag or eece lter bag into the dirt container.
▶ Always use lter bags in conjunction with folded lter cartridges.
NOTE
H-asbestos class vacuum cleaners should be preferably used as
vacuum cleaners for dry dusts.
l WARNING!
Health hazard !
Asbestos bres in the air.
▶ Supply the work area with sufcient outside air (fresh air).
▶ Guide or clean extracted air in such a way that asbestos
bres do not get into the breathing air of other persons.
▶ When ltering the extracted air, transport any dust in dust-
tight containers.
▶ Do not decant dust.
If there is a possibility of asbestos bres becoming free:
▶ Absorb asbestos bres at the outlet or point of origin.
▶ Then dispose of asbestos bres in accordance with the state of
the art without any danger to persons or the environment.
If complete absorption of asbestos bres is not possible:
▶ Take additional ventilation measures in accordance with the
state of the art.
After completion of the work:
▶ Carefully clean tools, including suction tubes and work
equipment.
▶ Carefully clean the working area.
▶ Moisten and properly remove objects contaminated with asbes
-
tos bres that cannot be cleaned.
After cleaning:
▶ Ventilate the working area sufciently.
6 Permanent lter cleaning
The vacuum cleaner is tted with an electromagnetic lter cleaning
system, which can be used to clean any attached dust from the
lter cartridges.
The folded lter cartridges are cleaned alternately one after the
other so that continuous work is guaranteed.
Continuous monitoring of the lter lling level through differential
pressure measurement, for an absolutely precise on-demand lter
cleaning during the operation.
Thereby constant high air ow cleaning guaranteed during the
operation, even for critical types of dust.
dif. = 0
dif. = max.
7 Emptying the container
NOTE
Only permitted for dust with workplace exposure limits > 1 mg/m³.
▶ Switch off the vacuum cleaner, pull out the mains plug.
▶ Open the latches.
▶ Remove the cover and suction hose from the container.
▶ Empty the container by pouring out.

Table of Contents