Instruction manual
19
Adjust the tilt angle of your monitor
1. To change the angle that the monitor is tilted at, use the 6 mm hex key to turn the
screw in the side of the VESA monitor mount counterclockwise.
2. When the screw is loose, position the monitor at the angle that works best for you.
3. Use the 6 mm hex key to turn the screw clockwise to tighten it. (gure 19)
+45°
-45°
6 mm hex key
gure 19
4. When you’re done adjusting the tilt angle, you can store the 5 mm hex key and the
6 mm hex key in the hex key holder in one of the cable-management clips.
(gure 20)
gure 20
Hex key holder
6 mm hex key
5 mm hex key
To Next Page
Loading...
