What to do if blower proving switch does not show continuity in State Water Heaters Water Heater?
- CcindymorenoSep 12, 2025
If the blower proving switch on your State Water Heaters Water Heater does not show continuity, replace the switch.
What to do if blower proving switch does not show continuity in State Water Heaters Water Heater?
If the blower proving switch on your State Water Heaters Water Heater does not show continuity, replace the switch.
Brand | State Water Heaters |
---|---|
Model | Ultra-Force STC-077 |
Tank Capacity | 77 gallons |
Maximum Temperature | 180°F |
Voltage | 480V |
Insulation | Non-CFC foam |
Describes the step-by-step heating cycle from call for heat to standby.
Essential checks and conditions to verify before starting troubleshooting.
Tests for 120 VAC power supply at the control board's CN1 terminal.
Checks for 120 VAC input and 24 VAC output from the transformer.
Verifies 24 VAC presence at the ECO probe and ensures proper function.
Checks the resistance of the upper and lower temperature probes.
Tests for continuity between pressure switch terminals.
Checks for 120 VAC power supply to the blower motor.
Measures air and gas pressures and checks switch continuity during operation.
Tests for 120 VAC power supply to the ignitor during warm-up.
Measures the resistance of the hot surface ignitor (HSI).
Checks for 24 VAC supply to the gas valve during ignition trial.