4.2 THE MENUS
The previous section explained how to get into program mode, to move around the
menus and how to edit. This section details the contents of the menus and explains
how to program the unit for your own particular application.
As described before, Program mode is entered by pressing ENTER then CYCLE
from the process variable display. This takes the system into the Root menu. The
Root menu is divided into five submenus: SETPOINTS, INPUTS, OUTPUTS,
SYSTEM and CALIBRATION.
Note: If there are analog output options fitted ( Current output or Voltage output ) in
both output slot positions, there will not be any setpoints available and the
SETPOINT submenu will be removed from the Root menu.
ROOT MENU
Page 34
To Next Page
Loading...
Need help?
General