To Next PageTo Next Page
Need help?Do you have a question about the stayer SC 250W PRO and is the answer not in the manual?
Describes suitable surfaces for tool operation.
Specifies types of wood, chipboard, and fiberboard the tool can process.
Lists PVC tubes as a material for cutting.
Details straight cutting capabilities along length and width.
Covers horizontal angle cutting range from -45° to +45°.
Describes vertical angle cutting capabilities from 90° to 45°.
Steps for safely removing the machine and accessories from its packaging.
Instructions for repacking the machine for storage or transport.
Steps to secure the machine's operating head in position.
Procedure for returning the machine to its original packaging.
Steps to adjust the machine's lower resting lock.
Procedure for setting horizontal mitre angles between -45° and +45°.
Steps to set the vertical angle to 90 degrees.
Procedure for setting the vertical angle to 45 degrees.
Notes regarding the applicability of this section to specific models.
Steps to verify the alignment of the upper table keel.
Procedure for adjusting the height of the upper table keel.
Important safety notice before changing tools.
Instructions for safely removing the cutting disk.
Specific steps for disk removal on the SC2500W model.
Procedure for installing a new cutting disk.
Notes on workpiece size limits for different models.
Details specific workpiece size capacities for various machine models.
Critical safety warnings for machine operation.
Procedures for safely starting and stopping the machine using manual switch or locking.
Safety warning for using the lower cutting table.
How to set up the upper table for lower table operations.
Guidelines for performing cuts using the lower table.
Setting for inclined horizontal cuts on the lower table.
Setting for vertical inclined cuts on the lower table.
Information about optional equipment for SC241W.
How to safely secure the workpiece before cutting on the lower table.
Applicability of this section to specific models.
Mandatory preparation before using the upper cutting table.
Steps to install the safety guard on the lower table.
Details on the adjustable height of the upper cutting table.
Safety warning regarding the upper table height relative to the disk.
Setting the cutting width on the upper table by means of the guide.
Information on goniometer use and model compatibility.
Lists essential personal protective equipment (PPE) for operating the machine.
Essential safety practices to follow during machine operation.
Identifies potential hazards like disk contact and workpiece projection, with accident scenarios.
Safety measures to avoid touching the rotating cutting disk during operation.
Methods to prevent ejected workpiece fragments and related risks.
Lists mechanical and electrical protective equipment for operator safety.
Instructions for regular cleaning, maintenance, brush replacement, and greasing.
Identifies tools that are standard or included with the machine accessories.
Comprehensive rules for safe use, including work area, electrical safety, and tool handling.
Details on avoiding unintentional starts, using correct accessories, and proper tool repair.
Outlines the warranty period and conditions for the equipment.
States the machine's compliance with relevant directives and regulations.
General
