Stealth 13V2S12 - User Manual

Questions and Answers

M
Michael PierceAug 5, 2025
What to do if my Stealth 13V2S12 motor does not turn on?
- B
  Bethany Bowman PhDAug 5, 2025
  If your Stealth Winches motor does not turn on, start by checking the remote lead and connections to ensure they are properly connected. Also, inspect the battery and its connections for any looseness. If the issue persists, the remote assembly might be defective, requiring a replacement. In some cases, the motor itself could be defective; check for voltage at the armature port while pressing the switch. If there's no voltage, consider replacing the motor. Lastly, if water has entered the motor, allow it to drain and dry completely, then run the winch until it is fully dry.
G
Gina HintonAug 11, 2025
Why is my Stealth 13V2S12 Winches motor overheating?
- E
  etrevinoAug 11, 2025
  If your Stealth Winches motor is overheating, it's likely because the winch has been running for too long. To resolve this, allow the winch to cool down periodically.
J
Joseph RodriguezAug 15, 2025
Why does my Stealth 13V2S12 Winches motor run slowly?
- H
  hroseAug 15, 2025
  If your Stealth Winches motor runs slowly or lacks normal power, it may be due to insufficient current or voltage. Try operating the winch while the vehicle motor is running.
D
dustin23Aug 21, 2025
What to do if Stealth 13V2S12 Winches motor runs in one direction only?
- T
  Tracy RobertsAug 21, 2025
  If your Stealth Winches motor runs in only one direction, the cause may be loose or corroded battery cable or motor cable connections. Clean and tighten these connections. If the problem continues, repair or replace the switch assembly.
N
nwilsonAug 26, 2025
What to do if Stealth 13V2S12 motor runs but drum does not turn?
- D
  Daniel AtkinsonAug 26, 2025
  If the motor runs but the drum does not turn on your Stealth Winches, turn the clutch to the “In” position. If the problem persists, ask a technician to check and repair it.
T
Tammy MillerAug 31, 2025
What causes a braking malfunction in Stealth 13V2S12 Winches?
- C
  Casey RhodesAug 31, 2025
  In case of a braking malfunction in Stealth Winches, make sure the cable runs in the right direction by adjusting it. If the issue persists, the brake slice might be worn or broken down, in which case you should adjust the braking angle or replace it with a new one.