STEALTH ELECTRIC BIKES OWNER’S MANUAL
V 2.4 PAGE | 24
COMFORT
In the interest of comfort and efficiency, components such as the seat, seat post, stem, handlebars and brake levers should
be adjusted to specifically suit the rider. This should only be done with the consultancy of or by a skilled bicycle mechanic.
REGENERATIVE BRAKING
The regenerative braking switch is located between the gear shifter the left-hand
brake lever. It is used to reverse the polarity of the motor and recharge the battery to
increase the range, it also increases the resistance of the rear wheel (causing it to
slow the bike) similar to applying the rear brake lightly. When riding on slippery or
loose surfaces avoid using the regen button as it may cause loss of traction and
control.
DC-1 AND ELECTRONIC SECURITY
The DC-1 is used to display real time information to the rider and to manage the bikes power output.
The DC-1 will require the owner to use a 4-digit security pin to turn the bike on. This number is unique to the bike and must
be obtained by contacting Stealth once your bike is assembled. Please contact Stealth via email or phone and provide us
with your name and bike number:
Email: sales@steatlhelectricbikes.com
Ph: +61 (0) 3 9574 0257
To enter your security pin you must first turn the bike on. Once the screen below is displayed, use the up and down
directional buttons to change the flashing digit to the correct number. Then press the OK button to move to the next digit.
Once the 4
th
digit is correct, press the OK button to enter the pin.
To Next Page
Loading...
