STEALTH ELECTRIC BIKES OWNER’S MANUAL
V 2.4 PAGE | 43
NOTE: Visually inspect brake pad thickness periodically for wear. Pads should be
replaced when pad thickness is less than 0.5mm.
EVERY MONTH
1. Check the tyre pressures and wheels. Replace any damaged components.
2. Ensure that steering head bearings, handlebars and associated bolts are tight.
3. Check the seat and seat post alignment and fasteners.
4. Ensure there is no fouling or excessive wear of wires and cables on the controls.
5. Check the frame for damage. High force loads can damage frame components.
6. Check for loose spokes and replace if necessary.
7. Spray CRC 5.56 through breather hole of motor for 2 full rotations of wheel. Spin wheel by hand 10-15 rotations.
EVERY SIX MONTHS
1. Replace transmission grease (refer to Schlumpf Speed Drive or V-Boxx manual).
2. Lubricate suspension and shock bushings.
3. Lubricate brake levers.
TROUBLESHOOTING
If you have any issues with your bike relating to the electrical system, Stealth customer support requires a legible photo of
the Diagnostic Data screen. If possible, take this photo while the problem is occurring.
To produce the photo needed, do the following:
1. Turn bike on and ride bike or turn wheel by hand for at least 5 full rotations of the wheel.
2. Press the MENU button twice to navigate to the settings page.
3. Use the directional buttons to navigate to the bottom of the page and the “OK” button to select “Diagnostic Data”
To Next Page
Loading...
