Model: TC-150
Steambath Control
07/07
Pub. No. 122-A
C
US
®
LISTED 995C
Installation and Operating Instructions
IMPORTANT: This control must be installed inside the
steam room for proper operation of the system.
Temperature Display: Indicates steam room or set
point temperature.
Start/Stop Key Pad: Press key pad and generator
will begin producing steam in a few minutes. The
generator will remain on for 30 minutes when used
with the models SM-46, SM-79, SM-4, SM-5, SM-7,
or SM-8 steam generators and 60 minutes for larger
generators. Pressing the key pad a second time will
stop the steam generator.
Steam Icon: Indicates the generator is producing
steam when illuminated. The heater in the generator
and the steam icon will cycle on and off as the
temperature is maintained automatically in the steam
room.
Up/Down Key Pads: Press to adjust the temperature
set point.
Cleaning Instructions: Use a damp cloth and mild soap.
Do NOT use abrasive cleaners which might scratch the
surface or the base of the control.
- 1 -
Control Features
Installation Instructions
The TC-150 control must be installed inside the
steam room. For convenience the recommended
height from the floor is four feet. Provide a 1½” hole
in the wall at this location (see Figure 1).
IMPORTANT: Multi-conductor cable must be
installed so that the end will not be buried inside the
wall. The unit will not operate unless the control is
installed.
1. Pre-Installation - Control Location
a)
Remove the multi-conductor cable from the control
packing box. Carefully route the multi-conductor
control cable from the steam generator to the
TC-150 located inside the steamroom (see Figure
2). Route multi-conductor cable through a ¾”
conduit to protect the cable from damage and to
facilitate replacement if necessary.
2. Electrical Rough-in
a)
1.
2.
3.
4.
TC-150
Digital Temperature Control
4
2
IMPORTANT: the TC-150 Control will only function with one of the following Steamist steam generator
models: SM-46, SM-79, SM-4, SM-5, SM-7, SM-8, SM-11, SM-12, SM-15, System-18, System-24,
System-30, and all InstaMist Generators.
1½“ Hole
located four feet
from the floor
Double-sided
Adhesive Pad
IMPORTANT: Run the
Control Cable through
a ¾” conduit.
Coupler
1
TEMPERATURE
START
STOP
3
TC-150 Digital
Temperature Control
Figure 1
WARNING: Elderly persons, pregnant women, or those suffering from heart disease, high blood
pressure, diabetes, or who are otherwise not in good health, do not use this device unless
directed to do so by a physician. Also, do not use steambath while under the influence of alcohol.
!
To steam generator
To Next Page
Need help?
General
