14
Getting started
∙ Doors and windows should be closed for an optimal cleaning performance.
∙ Press the release button on the back of the device to remove the motor part.
∙ Fill the water tank up to the “MAX” mark with water (0.75 liters). 2 drops of scen-
ted oil can also be added to the water.
∙ Then, snap the motor part back into place.
∙ Connect the device with the USB plug.
∙ By pressing the start / stop button, the device starts at level 1 and the control lamp
lights up. Pressing it again increases the power level (1 - 3). The fourth press swit-
ches the device off again.
∙ The air washer function is switched on by pressing button 5.
∙ The air intake and outlet must never be covered.
Troubleshooting
Dear Client,
Thank you for buying this STEBA product. The following table will help you with pro-
blems that may occur when using your device. For many problems there is a simple
solution, because not everything that appears like a malfunction must be serious.
Please check the following list before contacting our customer service.
Problem Reason Solution
Device does
not work
∙ Wrong output voltage
∙ Power supply not connected
∙ Connect the plug
∙ Adapter power must be high-
er than 5V, 1.5A
Air washer
does not work
∙ Bad contact
∙ The plate package is blocked
∙ Functional damage
∙ Put the motor part on cor-
rectly
∙ Clean the water tank
∙ Contact customer service
To Next Page
Loading...
