15
Cleaning and maintainance:
∙ The device should be cleaned after each use
∙ Unplug the device
∙ The device should cool down a little. It can be cleaned easier
when it is not that hot.
∙ Never immerse the device in water!
∙ Use a humid cloth with a little bit of detergent to clean it. Re-
sisting dirt should be covered with some oil, wait for ca 5 min
and try to remove it again with a humid cloth. Do not use abhe-
rasive cleaners. When cleaning the oil tray, be careful, that the
liquid in it is cooled down completely.
∙ Do not use agressive cleaners to avoid damages to the non-stick
surface.
Inserting the plates
The plates are easiest to change in the position.
1. Bottom plate:
Slide the flat bottom grill plate into retention catches at a slight angle, then lower plate
and engage by pushing the button on the left-hand side .
2. Top plate:
Slide top plate into retention hooks at a slight angle and engage by pressing the button
on the front side.
Always ensure that the fat collection tray is inserted into the bottom part.
3. Raise the slider to < LOCK for transport or vertical storage.
Before initial use:
Grease the grilling surface lightly before using for the first time. Then heat up the grill for ten
minutes at the maximum setting with the grill closed and empty. Then wipe the plates with
a damp cloth.
To Next Page
Loading...
