14
Preheating
By pressing the button the water will be slightly preheated to guarantee that the
water mist does not withdraw too much temperature from the ambient air. Ener-
gy consumption 100W. The display shows . By pressing once again, the heating is
stopped.
Timer
By pressing the button you can adjust the time up to 9 hours in steps of one hour.
The display shows the symbol . By pressing the button again, the display shows “C”
for continuous working.
Humidity
Press the button . The display shows the current humidity. Chose the humidity level
from 40 – 90% und confirm within 3 seconds by pressing once again. The recommen-
ded humidity is 45%-60%. As soon as the device has reached the adjusted humidity in
the room, it switches off.
Sleeping mode
By pressing this button the device works with a humidity of 65 – 70%. Display illumi-
nation and beeping are shut down. As soon as the device has reached the adjusted
humidity in the room, it switches off. By pressing once again the button the slee-
ping mode is turns off.
Ionization
By pressing the “Ionization” button the water mist will be enriched with negative
ions. This effect is like after a summer thunderstorm. Quantity of ions per cubic centi-
meter of air:
at high mountain 8000 ion/ccm
at the sea 4000ion/ccm
at the countryside 1200ion/ccm
in the city 200ion/ccm
in the office only 20 ion/ccm
Water level:
If no water is in the tank, the atomization will be interrupted and the display shows a
LED.
To Next Page
Loading...
