Need help?Do you have a question about the Steg DSP 6 and is the answer not in the manual?
Details the various input signal types available for connection to the DSP unit, including high-level and low-level options.
Explains how to connect the power supply and remote turn-on signal for the DSP device.
Step-by-step guide to installing the Digital Signal Processor Graphical User Interface software.
Provides instructions on how to navigate and use the DSP's Graphical User Interface.
An overview of the DSP's graphical user interface, detailing its sections and controls.
Options for setting channel modes including full-range, 2-way, and 3-way crossovers.
Lists all input and output connections, including RCA, speaker, optical, and remote.
Details technical specifications like frequency response, DSP resolution, power, and sampling rate.
General| Channels | 6 |
|---|---|
| Signal-to-Noise Ratio | >100 dB |
| DSP Sampling Rate | 96 kHz |
| Input Channels | 6 |
| THD + N | <0.01% |
| Total Harmonic Distortion | <0.01% |
| Power Supply | 12V DC |
To Next Page
