characteristics msk 3000
RMS @ 11V - 14V
RMS @ 11V - 14V
RMS @ 11V - 14V
RMS @ 11V - 14V
max pow. 4 Ω - 11V
max pow. 2 Ω - 11V
Hz -3 dB
stereo 4 Ω max pow. 1kHz
4 Ω max pow. DIM 100
dB (“A” weight)
4 Ω - 1kHz
Volt RMS
Kohm
V. Batt
stereo 4 Ω - A
stereo 2 Ω - A
A
Hz (12 dB oct,)
dB
Hz / dB
A
mm.
Kg.
supply +12 crossover type
supply gnd equalization frequency
rigth signal input
out speakers rigth - status light indicators
left signal output
out speakers rigth + equalization gain
rigth signal output
out speakers left - right channel sensitivity
hp module slot
out speakers left + left channel sensitivity
lp module slot
remote control +12 crossover“q” select
left signal input
Stereo 4 Ω power
Stereo 2 Ω power
Mono 4 Ω power
Mono 2 Ω power
Overall efficiency
Overall efficiency
Frequency response
Distortion
Intermodulation distortion
Linear noise-signal
Damping factor
Input sensitivity
Input impedance
Supply range
Max. power absorption
Max. power absorption
Min. power absorption
Cut frequency HP/LP/BP
Fuse
Dimensions
Weight
Channel separation
“Boost” operation
pag. 16
pag. 17
MASTER STROKE amplifiers have a stabilized internal power supply. The
technical characteristics are obtained (and do not alter) with a power supply voltage
of between 10,5 and 14.4V. The amplifiers are built and dimensioned to supply
power exceeding the declared rating. The value is indicated as "typical power". The
power declared is in any case the minimum guaranteed and always verifiable on the
amplifier, independent of the tolerances of the components used in its construction.
G.T. TRADING reserves the right to make any technical and aesthetic
modifications to the product without prior notice.
400 W x 2
800 W x 2
1.600 W x 1
3.000 W x 1
>58%
>50%
10÷80.000
<0,02%
<0,02 %
>97 (>100)
> 200
0,5 ÷ 5
>11
10,5 ÷ 16
108
220
3
22÷8.500
70
40÷120 / 0÷ +12
150 (outside)
620 x 60 x 255
9.500
To Next Page
